Kenwood KA-V9500 - Manual (Page 12)

Remote control operation
I Loading batteries
Replacing batteries
1. [f the TRANSMIT indicator does not light even when the
operation key is pressed, the batteries are exhausted.
Replace the batteries. We recommend that the alkaline batter­
ies (LR03/AM-4) which have longer service life be used.
2. The programmed contents are not immediately lost when the
batteries are removed for replacement. However, they could be
lost if the unit is left without batteries for more than 3 minutes.
In such a case, the programming should be performed again.
The function signals of the non-learning, or fixed keys are not
lost even in this case.
Note:
Avoid using old and new batteries together, as this may cause
corrosion.
I Operating range of the remote
control unit
The normal operating range may change depending on
temperature, humidity, and other environmental con­
ditions, but it is roughly specified as shown in the
figure.
Model name: RC-V9500L
Transmission system:
Infared pulse system
Notes:
1. if two or more remote control operation keys are to be pressed
successively, press each key securely and leave an interval of
more than 1 second between presses.
Pressing a key immediately after pressing another key may
cause malfunction.
2. Malfunction may occur in case direct sunlight or the light of a
high-frequency lighting fluorescent lamp enters the remote
control light receptor. In such a case, change the installation
position of the unit so that the malfunction does not occur.
12 KA-V9500 (En)