On-screen character display, H checking the modes [ remote control unit only i, H checking the modes – Kenwood KA-V9500 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
On-screen character display
The on-screen character display appears on the monitor TV screen when specific operations are performed. The
information on the present setup various modes can be checked by pressing the MENU key on the remote control
unit. Whether the on-screen display is displayed or not can also be set.
H Checking the modes
[ Remote control unit only I
Example: In case DSP.LOGIC and Parametric Equalizer is ON
1 Press the MENU key.
2 Press the MENU key more again.
ioNSCRE^l
raj
u
• Every time the key is pressed, the display changes from Fig.
^ •
The TV screen changes to the condition shown in Fig. (A)
(A) to Fig. (K) repeatedly in cycle.
^
The display which appears when the MENU key is pressed changes according to the mode of the unit.
Notes:
1. On-screen displays shown in Fig. (A) and Fig. (K) remains for about 1.5 second. Other displays will not change until the MENU key is
pressed,
2. If the above cycle is terminated with "INFORMATION OFF" display, the on-screen character display will not appear in later operations.
3. If it is required to have on-screen character display afterward, terminate the cycle with "INFORMATION ON".
KA-V9500(En)
17