Kenwood KA-V9500 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I How to program the remote control functions of other components
under the ^'learning" keys of this remote control unit
1 Set the LEARIM/USE switch to LEARIM.
4
Press the learning key of RC-V9500L under
which you want to program the function
signal.
ifDTfffaOfw' 0
lD'iQ|[ikK)€,0.: Q;Q^^G0CSi 1 :
Qi|'B dgSiCi’s'rajflo-o-at
• LEARN indicator will light up,
I Set the A/B/C select switch to the desired
* position.
[
Within 30 seconds after pressing the key
^ above, press and hold the key of the other
remote control unit which contains the func
tion to be programmed (stored).
Press and hold
ulaDWflmo 0 1 □¡'□T
BEiimioii 0
JB № Qw
c
H
jl
:8'Si a
c
a
• The LEARN indicator changes from steady lighting to blinking,
indicating that the function signal is being programmed.
[ Place the remote control unit of another com-
*
ponent with this remote control unit (RC-
V9500L) so that their heads (signal transmit
ters) face each other.
j When the LEARIM indicator goes off after
blinking twice, release your finger from the
key of the other remote control unit
Signal is programmed under this key.
> Be sure to hold the key of the other remote control unit
depressed until the LEARN indicator goes out.
» The programming is completed when the LEARN indicator
goes out after two times of blinking.
I To program another function signal under another key, repeat
steps 4 to 6 above.
KA-V9500 (En)
15