Denon AVR-3600 - Manual (Page 21)

7“4 Remote control unit learning function
If your AV components are not Denon products or if operation is not possible with the preset memory settings, the components' remote control signals
can be "learned" to enable remote control operation.
The buttons that can be "learned" are the CD, DAT and DECK system buttons (see page 18) and the VDP, VCR and TV system buttons (see page
20), (For the TV only, the A block buttons can also be "learned",)
Press the USE/LEARN selector button with the tip of a
pen etc,, to set the learn mode. Both the START and
LEARNED/TX indicators flash.
2, Set the program switch to the side to be "learned".
Set to the AUDIO side for the CD, tape deck or DAT posi­
tion, to the VIDEO side for the VDP, VCR or TV position.
AUDIO
AVRTAVC VIDEO
3. Set the program switch to the position to be "learned",
CD DECK DAT
VDP VCR TV
4, Set the remote control units so they are facing each oth­
er, then press the button to be "learned" on this unit's
remote control unit.
Transmitting windoxA's
Lit
This unit's remote
control unit
The indicator stops flashing and the START LED lights.
The learnable buttons are the buttons which can be op­
erated with the DENON system codes for the CD player,
DAT and tape deck, the buttons which can be operated
with the preset memory for the VCR, VDP and TV. For
the TV only, however, the buttons in the section indi­
cated "A" on the diagram above can also be "learned".
Use these to "learn" TV channels.
NOTE:
® Use button (tl)/ 0 as the 0 number button, button
@ / E as the enter button.
Check that the START LED is lit, then press the button
to be "learned" on the other remote control unit.
6, Once the START LED turns off and the LEARNED/TX
LED lights, release the button on the other remote con­
trol unit.
The two LEDs start flashing again.
7, To "learn" other buttons, repeat steps 2 to 6,
8. Once the learning operation is completed, press the
USE/LEARN selector button again.
The two LEDs stop flashing and the learning mode is
cancelled.
Check that the stored codes work properly.
NOTES:
Up to 26 codes can be "learned", but this number may be lower if the codes are long.
If a non-learnable button is pressed or two or more buttons are pressed at once, the two LEDs will once again light when the button(s) is
released,
if the codes could not be stored, the LEARNED/TX LED does not light after the START LED turns off. For limited number of models, codes
cannot be stored in RC-820.
If the two LEDs start flashing rapidly after the START LED lights, this means that the memory is already full, and the code you have just
attempted to store was not stored.
To "learn" that code, first perform the resetting operation.
21