Denon AVR-3600 - Manual (Page 28)

9-3 Using the Dolby Surround Pro Logic mode
1, Set the Dolby Surround mode.
MODE
DOLBY
SURROUND
Lights
Conventional program sources will automatically be decoded with
Dolby Pro Logic, while Dolby Digital AC~3 program sources will be
decoded with Dolby Digital AC-3.
2. If necessary, adjust the input level when analog sources are used
to obtain maximum dynamic range without overload.
A
ifJPtiT LEVEL
------ Lights
Set so that the indicator does not
light at places where the volume is
high.
^ For digital input sources, there is no need to adjust the input level.
(These buttons will not operate and the indicator will not light.)
Si The current input source, input level, etc., can be checked on the on
screen display, (screen 23)
3. Play a program source with the
! DOLsv auntmuNo { or
mark. For operating instructions, refer to the
AC;a D I G I T A L ^ , , ^ “
various components manuals.
9-4 Using the Dolby Digital AC-3 mode
1, Switch the audio input to AC-3RF input (a) or digital input (b).
The VDP picture is linked to the AC-3RF signals,
a. AC-3BF (VDP AUTO or VDP AC-3RFÌ input
Select the AC-3 RF input.
AC-3RF
[^Mi
When the button is pressed, the video input automatically
switches to VDP/DVD. The input mode switches as follows
each time the button is pressed;
l :
VDP AUTO -VDPAC-3RF
O Q-
( screen 23 )
This input mode makes it possible to play the Dolby Digital AC-3 audio, digital audio or analog audio signals recorded on the source by switching
between the priority and fixed modes for the AC-3RF, digital (opticaI/coaxial) or analog input jacks with the VDP/DVD function.
# VDP AUTO ....................... When AC-3RFsignals and digital and analog signals are input from the LD, the signals are automatically selected with
the following priority; AC-3RF -> digital or analog.
m VDP AC-3 RF.................. AC-3RF fixed Input
28