Programming operations, Dll (down line loading) operations – Toshiba TEC MA-1900 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EO1-110Q6
8. PROGRAMMING OPERATIONS
The system should be programmed fully according to the user’s requirements at the time of delivery
so that daily operations can immediately start. However, some data must be added or changed daily
or in a longer period. Please consult with your TEC representative about what programmings are
needed as user’s daily jobs and what programmings are to be contained as your TEC representative
service. Since the volume of programming contents for the system is large, the TEC representative
is entirely responsible of service and information on programming operations. Please also note that
some of the programming operations available on stand-alone ECR basis are not acceptable on
terminals of an in-line system.
9. DLL (Down Line Loading) OPERATIONS
In a Master-Satellite system, most programming data are set on the Master Terminal and down-line-
loaded (DLL) to Satellite Terminals. Since DLL operations are deeply connected with programming
operations, it is also your TEC representative’s responsibility to service or inform on DLL operations,
(Some of them are introduced in Chapter 6 and Chpater 10 of this manual.)
- 22 -