Flintec FT-16D V.1.21 - Manual (Page 16)

[312 ] Span Adjustment Under Load (for FT-16)
This parameter is being used to perform span adjustment of a scale without lifting the load from it. This
operation is especially used for span adjustment of filled tanks. You can make span adjustment without
removing the load in the tank.
When you press the <Enter> key the [P.ZEro ] message appears on the display. This means the scale
will take the current load as a temporary zero. After getting ready for this level, which means temporary
zero adjustment, the <Enter> key should be pressed. The display will show the [WAıt ] message during
the temporary zero adjustment. After this step the display will show [LoAd ] for a certain period and then [
XXXXXX ]. The value shown on the display is the weight that should be used for the span adjustment. If
the value of the test weight which will be used is different from the value shown on the display, type the
new value by <Tare> and <Zero> keys, place the test weight on the scale and press <Enter>. The display
will show the [WAıt ] message during the span adjustment under load. Approximately 10 seconds later
the display will show the [SAvE ] message. You can confirm the “Save span adjustment under load” by
pressing <Enter> or cancel it by pressing the <F> key.
FT-16(D) Technical Manual, Rev. 1.21 December 2008 Page 16 of 32