FXpansion DCAM Synth Squad Quick Start Guide - Manual (Page 24)

24
Preferences
1. Click the Preferences button in the
synth’s preset picker to bring up the
preferences panel.
3. Click the menu to show a list of
possible controllers – click on the
desired controller to select it.
Assigning performance controllers (Perf1 and Perf2)
All presets supplied with DCAM: Synth Squad feature the first 3 TransMod modulation slots assigned to the
following modulation sources:
• OnVel (note-on velocity)+
• Perf1+
• Perf2+
The performance controllers are shown to the left of the on-screen keyboard, and are intended to be mapped
to your hardware controllers that are most immediate to use.
The default assignments for the 2 performance controllers are:
•
P1 (Perf.1) = Modulation wheel (MIDI CC#1)
• P2 (Perf.2) = Mono pressure (channel aftertouch)
These assignments can be changed to any two performance controllers of your choice, using one of two
methods. The first is using the preferences panel:
Alternatively, you can use the MIDI Learn system (see opposite).
2. The Perf.1 and Perf.2 drop-down menus allow you to choose
a new assignment for each performance controller.
4. Click the Apply button to make the changes, which are saved
with the current session (but not the preset!). You must click
the
Save as Defaults button for the current preferences
settings to be persisted in future sessions.