FXpansion DCAM Synth Squad Quick Start Guide - Manual (Page 34)

34
Fusor
Fusor is an environment for:
• layering up to 3 DCAM synths
• applying FX processing
• advanced step-sequencing and arpeggiation with the Animator device
• performing modulation between the various loaded devices with the FuseMod system
Fusor is installed only as an instrument plugin – it cannot be used as an audio effect plugin.
Chapter 8 of the operation manual discusses Fusor in detail.
FuseMod
The FuseMod system (very similar to the TransMod system used in the synths) allows you to
modulate parameters between Fusor devices, including loaded DCAM synths. Most modulation
between FuseMod devices, such as Animator, the MonoMod LFOs/envelope followers and
the FX is monophonic. However, you can set up modulation between the synths using their
TransMod slots for polyphonic modulation between them.
High-quality FX suite
While the DCAM synths have no built-in FX, Fusor features a comprehensive suite of FX
featuring classic chorus, delay and phaser effects, circuit-modelled compression, filtering and
distortion, bit-crushing and high-quality reverberation with the licensed
Overloud Breverb algorithms. You can set up FX as inserts at various
points, or as aux sends, and FX parameters can be modulated via the
FuseMod system.
Animator step-sequencer/arpeggiator
Animator is Fusor’s built-in step-sequencer with arpeggiator and
parameter modulation sequencing functions.