FXpansion DCAM Synth Squad Quick Start Guide - Manual (Page 37)

37
4. Switch to the Global
page.
1. After working through the ‘Layering synths’ tutorial above, click on the Aux
FX page button.
2. Move the mouse over FX slot 1 and load Breverb Hall from the device
selector that appears.
Setting up a reverb as an Aux
3. Increase the Wet Mix control on
Breverb Hall to 100%.
5. On synth channel 1, increase the level
for Aux send 1.
1. Load synths into channels 1, 2 and 3 and load presets into each of them.
2. Switch to the Key Map page and turn off all the Animator buttons in the Destinations area for the first key
map. Then, turn on the 3 Synth buttons in the Destinations area.
Layering synths