GTCO DrawingBoard VI - Quick Start Guide - Manual (Page 2)

Installing the Driver
Insert the CD into the CD-ROM drive on your computer and follow the onscreen prompts to
complete the driver installation. If the CD does not autorun, click the Start button on the
Windows Task Bar and select Run from the menu. Type X:\setup.exe (X represents the CD
drive letter).
Hardware Configuration
Installing DrawingBoard VI
NOTE: Connect ONLY USB or the optional serial – not both.
USB Connection – With TabletWorks CD Only –
1. Connect the corded transducer – cursor or pen – to the appropriate jack on the
digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack.
Do not force it.
2. Attach the USB interface cable to the USB jack on the DrawingBoard VI Connector
Panel. The connector is keyed and will fit only the correct jack. Do not force it.
3. Join the other end of the USB cable to any one of the USB ports on your
computer or USB hub. Turn the power switch on. The digitizer will beep once,
indicating it has power.
NOTE: Power is supplied through the USB port. No additional power source is needed for
a USB installation.