GTCO Roll-Up III - Quick Start Guide - Manual

Contents
Verify that your Roll-Up III package includes the following:
 Roll-Up III digitizer and controller
 Transducer (stylus, 4-button or 16-
button cursor)
 USB cable
 CD with TabletWorks driver and
user’s manual
 Accessory pouch*
 Shipping/storage tube with insert*
*Do Not Discard
Optional Equipment
 Plan hold down clamps
 Deluxe travel case
 QuikRuler LCD module
 Serial interface cable and power
supply kit
Hardware Configuration
NOTE: Setup the hardware connections for USB or serial FIRST, following the instructions
below, then install the software.
Installing Roll-Up III
The following instructions describe how to assemble your Roll-Up III. Select a large, flat,
non-metal surface on which to place the digitizer. Clear all items from the surface.
NOTE: Conductive materials, inks, or
electronic devices on, under, or near the
Roll-Up III can cause improper operation.