GTCO AccuTab VI - Quick Start Guide - Manual

Contents
Verify that your AccuTab package includes the following:
 AccuTab VI digitizing tablet
 16-button high accuracy, illuminated
cursor
 USB cable
 Universal mounting brackets
 CD with drivers and diagnostics
(varies with configuration)
 User’s guide
 Registration card
Optional Equipment
 RS-232 cable with 9-pin connector for
serial connection
 Power supply – required only for a
serial installation
 Transducer (corded or cordless pen,
4-button or 16-button cursor)
 Plan holder
 Accessory tray
 Table feet
 Manual lift/manual tilt pedestal
NOTE: Some digitizing applications (typically, non-Windows CAD applications where the
tablet is used solely as a digitizer with no mouse functions) may not require the use of the
TabletWorks software. To configure AccuTab VI for use with a third-party application,
please refer to the installation instructions in the AccuTab VI User’s Guide, where you will
find a complete list of vendor configuration settings.
NOTE: If your digitizing tablet came with a TabletWorks CD, install the software FIRST, and
then setup the hardware connections for USB (or the optional serial), following the
instructions below.
Software Configuration
Software drivers provide the communication bridge between your software application and
AccuTab VI. The GTCO CalComp by Turning Technologies-supplied TabletWorks CD
supports reduced functionality Wintab and TabCon-compatible applications. If you are not
sure about your application’s driver requirements, contact your application vendor.