GTCO Super L IV - Quick Start Guide - Manual

Contents
Verify that your Super L IV package includes the following:
 Super L IV digitizing tablet
 Transducer (corded or cordless pen,
4-button or 16-button cursor)
 Computer interface with 9-pin
connector for serial connection
 USB cable
 Power supply – required only for
serial installations
 CD with drivers and diagnostics
(varies with configuration)
 User’s guide
Optional Equipment
 Plan holder
 Accessory tray
 Mounting brackets
 Manual lift/manual tilt stand
 Two feet
 Registration card
NOTE: Some digitizing applications (typically, non-Windows CAD applications where the
tablet is used solely as a digitizer with no mouse functions) may not require the use of the
TabletWorks software. To configure Super L IV for use with a third-party application, please
refer to the installation instructions in the Super L IV User’s Guide, or the Super L IV Help
file, where you will find a complete list of vendor configuration settings.
NOTE: If your digitizing tablet came with a TabletWorks CD, install the software FIRST, and
then setup the hardware connections for USB or serial, following the instructions below.
Software Configuration
Software drivers provide the communication bridge between your software application and
the Super L IV. GTCO CalComp by Turning Technologies-supplied TabletWorks CD supports
reduced functionality Wintab and TabCon-compatible applications. If you are not sure
about your application’s driver requirements, please contact your application vendor.