GTCO Super L IV - Quick Start Guide - Manual (Page 3)

3. Plug the power supply into an AC outlet. Join the power supply to the appropriate
jack on the Connector Panel. Turn the power switch on. The digitizer will beep four
times, indicating it has power.
4. To prepare the digitizer for driver support, use the transducer to click on the
buttons on the SuperSet Menu. If you are using a cordless
transducer, press a button to take it out of Sleep Mode before clicking on the
SuperSet Menu buttons.
USB Connection – With TabletWorks CD Only –
1. Connect the corded transducer – cursor or pen – to the appropriate jack on the
digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack.
Do not force it.
2. Attach the USB interface cable to the USB jack on the Super L IV Connector Panel.
The connector is keyed and will fit only the correct jack. Do not force it.
3. Join the other end of the USB cable to any one of the USB ports on your
computer or USB hub. Turn the power switch on the Connector Panel on. The
digitizer will beep four times, indicating it has power.
NOTE: Power is supplied through the USB port. No additional power source is needed for
this installation.
4. If Windows displays the Found New Hardware prompt, follow the onscreen
instructions to finish the Found New Hardware process.