GTCO Summagrid VII - Quick Start Guide - Manual (Page 2)

Installing the Driver
Insert the CD into the CD-ROM drive on your computer and follow the onscreen prompts to
complete the driver installation. If the CD does not autorun, click the Start button on the
Windows Task Bar and select Run from the menu. Type X:\setup.exe (X represents the CD
drive letter).
Hardware Configuration
Installing Summagrid VII
NOTE: Connect ONLY USB or serial – not both.
RS-232 Serial Connection
1. Connect the corded transducer – cursor or pen – to the appropriate jack on the
digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack.
Do not force it.
2. Attach the RS-232 serial cable to the serial jack on the Connector Panel. The
connector is keyed and will fit only the correct jack. Do not force it. Join the 9-pin
connector of the serial cable to the serial port on your computer.