Haltech F10 User Manual
Page 12
7
•
Throttle Position Sensor
10
k
Ω
rotary potentiometer driven from throttle shaft
•
Engine Speed Pickup
Compatible with most “ standard trigger” systems:
-
5 or 12 volt square wave;
-
Pull-to-ground (open collector)
-
Coil Negative triggering
ECU Outputs
•
Injector Driver
F10 and F10A Only
8 x 4/1Amp peak-and-hold current limiting drivers:
-
Up to 4 low-impedance injectors*
-
Up to 8 high-impedance injectors*
F10-8 and F10A-8 Only
8 x 4/1Amp peak-and-hold current limiting drivers:
-
Up to 8 low-impedance injectors*
-
Up to 16 high-impedance injectors*
(Expandabl e using optional Driver Box; Refer B.3 Injector Driver Box, 88)
F10A and F10A-8 Only
•
Pulse Width Modulated (PWM) Output
4 x Dedicated PWM outputs
-
Suitable for controlling turbo wastegate, solenoids, valves, shift lights, etc.
•
Fuel Pump Control
20A fused relay, features automatic priming and switch-off.
F10A and F10A-8 Only
•
Stepper Motor driver for idle control
Capable of driving bipolar stepper motors used for idle control.
* Additional hardware may be required
System Programming Requirements
•
Computer
IBM-PC or compatible, preferably laptop or notebooks
CGA, EGA or VGA, colour or monochrome display
640+
kb
RAM
•
Disk Drive
3.5" Floppy Disk Drive
(5.25" disk available on request)
•
Serial Port
Standard RS232C port - 9 pin D connector
(25 pin cable available on request)
COM1 or COM2 (selectable)