Haltech F10 - Manual (Page 28)

23
If you do not have a Hard Disk, go to the section titled Running the Software from the
Floppy Drive.
To install the software follow these steps.
Boot up Computer
Turn your PCs power on and boot up M S-DOS as instructed by the computers Users M anual.
If a shell program or menu utility runs automatically when you boot your computer, exit it
now. You should see something like this:
C:\>_
This is the ‘DOS Prompt’. It is DOS’ way of indicating that it is waiting for a command. The
C: indicates that the C drive is the drive currently selected. If you do not have a hard disk,
your prompt will probably look like this :
A:\>_
Select the Drive
To run the INSTALL program, you must insert the supplied disk in the disk drive. If the drive
is the A drive, then it must be currently selected. To select the A drive (or B drive if it is the
required drive) type :
D y
or
% y
The y
y y y key is the Enter Key. On some keyboards it may be called the Return key. You should
now see the prompt :
A:\>_ or B:\>_
Run the INSTALL Program
To run the Install program type :
LQVWDOOy
The Install program will now run. Follow the instructions given. The program will suggest
that the software will be placed in the HALTECH directory. You can change the destination
directory, but it is not recommended that you do unless you understand how directories work.
When it is finished, the installation program will tell you if the installation is successful. If it
was not, consult the trouble shooting section of this manual.
The F10 Program is now ready to run.