Haltech F10 - Manual (Page 41)

36
Groups of adjacent bars may be highlighted and adjusted together.
Hold
t t t t
while using the left or right arrow keys,
r r r r q q q q
, and you will highlight a group of
bars. This group will now act in unison when increasing or decreasing the height of the Bars.
To de-select the highlighted Bars use the
s s s s
and arrow keys together.
4.5.4 Percentage Changes
Pressing Alt-P will prompt you to enter a percentage change to the selected bars. An entry of
"20" will increase each bar by 20%, while an entry of "-15" will decrease the bars by 15%.
This change only affects the highlighted bar(s).
4.5.5 Linearise
When a group of bars is selected (more than two), this function can be used to set the values
between the end points. Highlight the bars between two load points that are known to be
correct and press
sO sO sO sO
. The programming software will automatically adjust all the bars
between the two end points to form a straight line. This feature facilitates fast programming
and the smoothing of maps.