Haltech F10 - Manual (Page 29)

24
2.2.3 Running the Software from the Hard Disk
Boot your computer up as described earlier. If your computer is already on, make sure the C
drive is currently selected. To change to the HALTECH directory type :
F'?KDOWHFKy
or, if you used a different destination directory, type that path.
To start the program type :
)y
The F10 program will now run. The next section is on running the software from a floppy
drive. You can skip this section and go straight to the section entitled Azerty Keyboards.
2.2.4 Running the Software from the Floppy Disk
To run the software from a floppy drive, boot your computer up as described earlier. Insert the
Programming disk in the disk drive. If the drive is the A drive, then it must be currently
selected. To select the A drive (or B drive if it is the required drive) type :
D y
or
% y
You should now see the prompt :
A:\>_ or B:\>_
To start the F10 program type :
)y
The F10 program will now run.
2.2.5 Azerty Keyboards
M ost countries use a keyboard where the first six letter keys across the top row are :
TZHUW\
This is called a Qwerty keyboard. Some countries use an alternative, which is called an
Azerty keyboard, where the Q and W keys are swapped with the A and Z keys respectively. If
you have an Azerty keyboard, you need to run the software slightly differently. When you
would normally type:
)y