Heli-Max HMXE0837 - Manual (Page 10)

10
Moving the left stick
left or right will cause
the quad to rotate in
that direction.
Rotates Left or Right Rotates Left or Right Rotates Left or Right
®
ADJUSTING THE FLIGHT SENSITIVITY ADJUSTING THE FLIGHT SENSITIVITY
You can make your 1SQ V-cam fl y more aggressively by changing the gyro
sensitivity. To do this press and hold the right control stick down so the
transmitter will emit a slow beeping sound. While holding the control stick
down so the transmitter will continue to beep, move the left control stick up
or down to adjust the sensitivity percentage shown on the LCD screen. A
higher value will make the 1SQ V-cam fl y more aggressively and lower value
less aggressively. We have found 35% to 40% a good all-around setting.
WARNING: If this value gets bumped to 0 your quadcopter will respond very
slowly to any right stick input. If the value is set too high the quadcopter will
be overly sensitive and might be impossible to fl y.
®
FLIPPING THE V-CAM FLIPPING THE V-CAM
To fl ip the V-cam, press and hold the fl ip button. Quickly move the right stick
in the direction you want to fl ip. To maintain altitude, it’s a good idea to be
climbing before you fl ip to give the Quadcopter upward momentum.
®
VIDEO AND PICTURE TAKING VIDEO AND PICTURE TAKING
To enter video mode, press the video button once. Press the button again
to start taking video. You will see the LED on the side of the V-cam fl ash
when video is being captured. To turn the video off simply press the video
button again and the LED will remain steady on. To switch to picture taking
mode press the picture button one time to enter picture mode. Press the