Heli-Max HMXE0837 - Manual (Page 13)

13
Futabs / Tactic
Transmitter Settings AILE
1
ELEV
2
THRO
3
RUDD
4
AUX
5
AUX
6
Function
Dual Rate
EXPO
Timer
N
100/100
100/80
0/-20
Servo Rev
Travel
N
100/100
100/80
0/-20
N
100/100
5 min
N
100/100
100/100
NULL
Flip
N
100/100
Video
N
100/100
AUX
7
Picture
N
100/100
Spektrum / JR
Transmitter Settings AILE
1
ELEV
2
THRO
3
RUDD
4
AUX
5
AUX
6
Function
Dual Rate
EXPO
Timer
R
100/100
100/80
0/20
Servo Rev
Travel
R
100/100
100/80
0/20
R
100/100
5 min
R
100/100
100/100
NULL
Flip
R
100/100
Video
R
100/100
AUX
7
Picture
R
100/100
To adjust the sensitivity of the controls, raise or lower the end point (travel)
settings.
Connecting the AnyLink ™ module or an SLT ™ compatible transmitter to your
heli.
1. Turn on the transmitter. Make sure the throttle is at zero.
2. Place the transmitter close to the model.
3. Remove the canopy and locate the small black link button on the PC
board.
4. Press and hold the button for 3
seconds.
5. Release and wait 3~5 more
seconds. Your system is now
ready!
This procedure is to be used to link
the V-Cam receiver to a stock TX460
transmitter, a “SLT ready” transmitter
with at least 6 channels, or an Anylink
when connected to a compatible
transmitter with at least 6 channels.
YOU MUST USE AN OPEN CHANNEL FOR EACH OF THESE FUNCTIONS.
The Dual Rate switches cannot be used unless they can be programmed to
control a specific channel i.e. 5, 6, 7 or 8. Make sure you have the intended