Heli-Max HMXE0837 - Manual (Page 15)

15
®
FLYING YOUR 1SQ V-CAM FLYING YOUR 1SQ V-CAM
❏
Move the left stick to the lowest position and then turn the transmitter on.
Electric motors are very dangerous. Do not work on the
model while the flight battery is plugged in as interference
may cause the main rotor blades to spin, possibly causing
injury to yourself.
❏
Install the flight battery by sliding
the battery into the bottom of the quad.
Make sure the battery is slid all the way
to the stop of the battery tray. Connect
the battery to the connector.
NOTE: The quad will be “ON” at this
point. Place the quad on a flat surface
for 2 seconds to calibrate the TAGS-FX.
Your quadcopter has a safe start
feature built in that prevents the motors from activating unless the throttle
stick has been lowered to the lowest position. If the motors won’t run and
turn the blades, please make sure the throttle stick is all the way down and
leave it there for a couple of seconds. Then try moving the stick up slowly.
Takeoff
If flying outdoors it’s important to stick to light winds. If you are taking off
and landing in grass, place a rubber mat or pad down on the grass so the
small rotating parts don’t get hung up in the grass.