Heli-Max HMXE0802 - Manual (Page 24)

24
NOVUS CX – REPLACING THE FLYBAR
Remove the flybar linkage from
the blade grip. Press outward
on one side of the head block
and simply rotate the flybar
carrier from the head block.
Once the flybar carrier has
been removed, press the flybar
weights inward and turn them
90 degrees. Now pull them off
the end of the flybar. Remove
the flybar linkage from the old
flybar and install the linkage
onto the new flybar. Install the
flybar weights onto the new flybar and slide the flybar pivot back onto the head
block. Reinstall the flybar linkage.
NOVUS CX – REPLACING THE MAIN GEAR
The Novus CX uses an inner
solid main shaft and a hollow
outer main shaft. Remove
the lower main gear retaining
screw. The lower gear will
simply drop down off the main
shaft. If you need to replace
the upper main gear, slide it
down off the main shaft and
reinstall the new gear ensuring
that the flat spot molded inside
the gear aligns with the main
shaft. Reinstall the lower gear
ensuring that the screw aligns
with the flat spot machined on
the inner main shaft.