Heli-Max HMXE0802 - Manual (Page 26)

26
NOVUS CX – REPLACE THE TAILBOOM
Loosen the tail boom screw
and slide the tail boom out
of the frame. Loosen the two
screws used to attached the tail
fin and tail assembly to the tail
boom. Slide the tail assembly
from the tail boom.
Please note that there are two
small holes at the back of the
tail boom and these must be
aligned with the tail assembly.
Install the tail assembly onto
the new tail boom and carefully
tighten the two screws used to attach the tail fin to the tail assembly. Slide the tail
boom into the main frame. Ensure that the tail fin is vertically aligned with the main
shaft and tighten the front tail boom screw.
NOVUS CX – REPLACING A MOTOR
The Novus CX uses two
separate drive motors. The
upper blade motor is located
on the left side when looking
at the bottom of the helicopter
with the nose facing upwards.
The lower blade motor is
located on the right side.
Once you have determined
which motor needs replacing,
unplug the motor from the E-
Board, remove the appropriate
motor mounting screws and in-
stall the new motor. Plug the motor connector into the E-Board.