Heli-Max HMXE0802 - Manual (Page 25)

25
NOVUS CX – REPLACING THE MAINSHAFT AND UPPER HEAD
The Novus CX uses an inner
solid main shaft and a hollow
outer main shaft. Remove
the lower main gear retaining
screw.
When performing
the following step please be
careful not to lose any small
bearings or bearing blocks.
Slide the inner shaft and upper
rotor head from the outer main
shaft by pulling upwards. If you
need to remove the lower shaft,
disconnect the servo linkages
from the swashplate and pull
upwards. Transfer necessary
parts from the old shaft to the new shaft and install following the reverse order
listed above.
NOVUS CX – REPLACING THE TAIL SHAFT AND TAIL ROTOR
Remove the tail rotor retaining
screw. Replace the tail rotor
blade and reinstall the tail rotor
retaining screw