HONDA 2006 Odyssey - Owner's Manual - Manual (Page 167)

Doing any of the following after
pressing the MEMO button will
cancel the storing procedure.
Not pressing a memory button
within 5 seconds.
Readjusting the seat position.
Each memory button stores only one
seat position. Storing a new position
erases the previous position stored in
that button’s memory. If you want to
add a new position while retaining
the current one, use the other
memory button.
To select a memorized position, do
this:
Make sure the shift lever is in
Park. Press on the brake pedal.
Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
The system will move the driver’s
seat to the memorized position. The
indicator in the selected memory
button will flash during movement.
When the adjustment is complete,
you will hear two beeps, and the
indicator will stay on.
To stop the system’s automatic
adjustment, do any of these actions:
If desired, you can use the
adjustment switches to change the
seat position after it is in its
memorized position. If you change
the memorized position, the
indicator in the memory button will
go out. To keep this seat position for
later use, you must store it in the
driver’s seat position memory.
Shift out of Park.
Push any of the adjustment
switches for the seat.
Press any button on the control
panel: MEMO, 1, or 2.
1.
2.
Selecting a Memorized Position
Driver’s Seat Position Memory System
166
MEMORY BUTTONS
Main Menu Table of Contents