HONDA 2006 Insight - Owner's Manual - Manual (Page 117)

You can switch into and out of
Second mode with the ignition
switch in the ON (II) position and
the shift lever in D position. If you
turn the ignition switch to the
ACCESSORY (I) position in Second
mode, the mode is switched to Drive. To shift to Low, press
the release button on the side of the
shift lever. Use Low to get more
power when climbing, and for
maximum engine braking when
going down steep hills.
For faster acceleration when in D or
L, the transmission will automatically
‘‘kick down’’ to a lower range of
ratios when you push the accelerator
pedal to the floor.
If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
rpm below the red zone.
The ‘‘S’’ indicator also comes on for a
few seconds when you turn the
ignition switch to the ON(II) position.
Automatic Transmission (CVT)
Low (L) Engine Speed Limiter
116
Main Menu Table of Contents