Service station procedures – HONDA 2006 Insight - Owner's Manual User Manual
Page 98
Wait a few minutes after turning the
engine off before you check the oil.
Remove the dipstick again, and
check the level. It should be
between the upper and lower
marks.
If it is near or below the lower mark,
see
on page
.
Pull the support rod out of its clip
and insert the end into the
designated hole in the hood.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
Remove the dipstick (orange loop).
Wipe off the dipstick with a clean
cloth or paper towel.
Insert it all the way back in its hole.
3.
3.
1.
2.
4.
Oil Check
Adding Oil
Service Station Procedures
B
e
fo
re
D
riv
ing
97
CLIP
SUPPORT ROD
DIPSTICK
UPPER MARK
LOWER MARK
Main Menu
Table of Contents