HONDA 2001 S2000 - Owner's Manual - Manual (Page 167)

Cooling System
5. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
6. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
Apply non-hardening sealant to the
drain bolt threads, put a new
washer on the drain bolt, and
reinstall the bolt in the engine
block. Tighten it securely.
Tightening torque:
61 lbf.ft(83 N.m , 8.5 kgf.m)
7. Loosen the bleeder bolt on top of
the engine, and remove the
bleeder cap near the engine oil fill
cap.
Maintenance
RESERVE TANK CAP BLEEDER BOLT
HOLDER RESERVE TANK
Main Menu Table of Contents