HONDA 2001 S2000 - Owner's Manual - Manual (Page 168)

Cooling System
8. Pour Honda All Season
Antifreeze/Coolant Type 2 into
the radiator up to the base of the
filler neck. This coolant is a
mixture of 50 percent antifreeze
and 50 percent water. Pre-mixing
is not required.
The cooling system capacity is:
1.72 US gal (6.5 , 1.43 Imp gal)
9. Tighten the bleeder bolt and
reinstall the bleeder cap when
coolant comes out in a steady
stream with no bubbles.
10. Start the engine and let it run for
about 30 seconds. Then turn off
the engine.
11. Pour coolant into the radiator up
to the base of the filler neck.
12. Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
13. Install the radiator cap, and
tighten it to the first stop.
14. Start the engine and let it run until
the radiator fan comes on two
times. Then stop the engine.
CONTINUED
Maintenance
BLEEDER CAP Fill up to here
FILLER NECK
RESERVE TANK
Main Menu Table of Contents