HONDA 2001 CR-V - Owner's Manual - Manual (Page 255)

Lights
5. Install the new bulb in the socket.
6. Insert the socket back into the
rear side marker light assembly.
Turn it clockwise to lock it in place.
7. Test the lights to make sure the
new bulb is working.
8. Put the mudguard back in place
and secure it with the three
screws.
Replacing a High-mount Brake
Light Bulb
1. Remove the light assembly cover
by pushing the tabs on both sides
and pulling the cover down.
2. Remove the socket from the light
assembly by turning it one-quarter
turn counterclockwise.
3. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
4. Test the lights to make sure the
new bulb is working.
5. Put the socket back into the light
assembly and turn it clockwise to
lock it in place.
6. Put the cover back onto the light
assembly. Push it up until it locks
in place.
Maintenance
Main Menu
Main Menu Table of Contents