Jump starting – HONDA 2001 CR-V - Owner's Manual User Manual
Page 282
Jump Starting
4. Connect the second jumper cable
to the negative ( — ) terminal on
the booster battery. Connect the
other end to the ground wire on
the right side of the engine as
shown. Do not connect this jumper
cable to any other part of the
engine.
5. If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
6. Start your vehicle. If the starter
motor still operates slowly, check
the jumper cable connections to
make sure they have good metal-
to-metal contact.
7. Once your vehicle is running,
disconnect the negative cable from
your vehicle, then from the
booster battery. Disconnect the
positive cable from your vehicle,
then the booster battery.
Keep the ends of the jumper cables
away from each other and any metal
on the car until all are disconnected.
Otherwise, you may cause an
electrical short.
Taking Care of the Unexpected
BOOSTER BATTERY
Main Menu
Main Menu
Table of Contents