HONDA 2000 Accord Sedan - Owner's Manual - Manual (Page 255)

Lights
Replacing Front Turn Signal and
Side Marker Light Bulbs
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger's side, turn
the steering wheel to the left.
2. Use a flat-tipped screwdriver to
remove the holding clip from the
inner fender.
3. Pull the inner fender away from
the fender and bumper.
4. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
5. Remove the burned out bulb from
the socket by pushing it in and
turning counterclockwise until it
unlocks.
6. Install the new bulb in the socket.
Turn it clockwise to lock it in place.
7. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
8. Test the lights to make sure the
new bulb is working.
9. Put the inner fender in place.
Install the holding clip. Lock it in
place by pushing on the center.
Maintenance
HOLDING CLIP
Main Menu Table of Contents