HONDA 2000 Accord Sedan - Owner's Manual - Manual (Page 86)

HomeLink Universal Transmitter
4. Press and release the button on
the HomeLink transmitter. (The
same button you trained with
the "Training the Transmitter"
procedure.)
5. Press and release the
HomeLink transmitter button
again. This should turn off the
training light on the garage
door opener unit. (Some
systems may require you to
press and release the button up
to three times.)
6. Press the transmitter button
again. It should operate the
garage door.
Retraining a Button
To train an already programmed
transmitter button to operate a new
device:
1. Select the transmitter button
you want to train.
2. Press and hold the transmitter
button until the red light begins
to flash slowly (approximately
20 seconds).
3. While continuing to hold the
transmitter button, place the
remote control for the device 1
to 3 inches from the HomeLink
transmitter.
4. Press and hold the button on the
remote control. Hold both
buttons until the red light
begins to flash rapidly.
5. Release both buttons. The
transmitter should now be
trained to operate the device.
Erasing Codes
To erase the codes stored in all
three buttons, press and hold the
two outside buttons until the red
light begins to flash, then release
the buttons.
You should erase all three codes
before selling the vehicle.
As required by the FCC:
This device complies with Part 15
of the FCC rules. Operation is
subject to the following two
conditions: (1) This device may not
cause harmful interference, and (2)
this device must accept any
interference received, including
interference that may cause
undesired operation.
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the
following two conditions: (1) this
device may not cause interference,
and (2) this device must accept any
interference that may cause
undesired operation of the device.
Instruments and Controls
Main Menu Table of Contents