HONDA 2000 Accord Sedan - Owner's Manual - Manual (Page 257)

Lights
Replacing Rear Bulbs
(in Fenders)
1. Open the trunk.
Remove the fastener on the side of
the trunk lining by turning it
counterclockwise with a coin. Pull
the lining back.
2. Determine which of the two bulbs
is burned out: stop/taillight or turn
signal.
3. Remove the socket by turning it
one-quarter turn counterclockwise.
4. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
5. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
6. Test the lights to make sure the
new bulb is working.
7. Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
8. Put the fastener in the hole on the
side of the trunk lining and push
on the center until it locks (the
center is flush with the head).
Maintenance
FASTENER
Main Menu Table of Contents