IC Realtime Combo Series: 8 Channel DVR with built-in 19 LCD monitor - Manual (Page 110)

101
Figure 7-41
Please refer to the following sheet for detailed information.
Parameter Function
Event
Type There are three types: Motion detection/video loss/Camera Masking.
Channel Select channel name from the dropdown list.
Enable You need to draw a circle to enable motion detection function.
Sensitivity There are six levels. The sixth level has the highest sensitivity.
Region z There are six levels. The sixth level has the highest sensitivity.
z Region: If you select motion detection type, you can click this button
to set motion detection zone. The interface is shown as in
X469H469H469H
Figure
7-41
X
. There are PAL 22X18/NTSC 22X15 zones. Right click mouse
you can go to full-screen display mode. Do remember clicking OK
button to save your motion detection zone setup.
Period z Motion detection function becomes activated in the specified
periods.
z There are six periods in one day. Please draw a circle to enable
corresponding period.
z Select date. If you do not select, current setup applies to today only.
You can select all week column to apply to the whole week.
z
Click OK button, system goes back to motion detection interface;
please click save button to exit.
Anti-dither System only memorizes one event during the anti-dither period. The
value ranges from 0s to 15s.
Normal
out z There is 2-channel alarm output.
z
Corresponding to motion detection alarm output port(multiple
choices)
z Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
alarm occurs.