IC Realtime 4 Channel PoE Mobile Network Video Recorder - Manual (Page 140)

131
6.4.4 Additional Function
6.4.4.1 IPC Config
IPC configuration interface is shown as in Figure 6-60.
Here you can set gain, iris, brightness, contrastness, hue, saturation BLC and etc of the network
camera.
Figure 6-60 IPC Config
Please refer to the following sheet for detailed information.
Parameter Function
Brightness It is to adjust monitor window bright. The value ranges from 0 to
100. The default value is 50.
The larger the number, the bright the video is. When you input
the value here, the bright section and the dark section of the
video will be adjusted accordingly. You can use this function
when the whole video is too dark or too bright. Please note the
video may become hazy if the value is too high. The
recommended value ranges from 40 to 60.
Contrast It is to adjust monitor window contrast. The value ranges from 0
to 100. The default value is 50.
The larger the number, the higher the contrast is. You can use
this function when the whole video bright is OK but the contrast
is not proper. Please note the video may become hazy if the
value is too low. If this value is too high, the dark section may
lack brightness while the bright section may over exposure .The
recommended value ranges from 40 to 60.