Intellijel Corgasmatron (draft) - Manual (Page 4)

Rear Panel
Corgasmatron Manual v1.0
Page 4 of 10
1 - XFade Adj. This trimmer adjusts the blend between channel A and channel B of the xfader.
To adjust make filter A resonate at 1 Khz, set routing configuration to parallel and monitor out
the MIX out. Turn the Xfade front panel knob fully CW so as to only pass filter B. Now adjust
the trimmer slowly until the filter A is no longer heard. This is calibrated at the factory.
2 - jumper, Q behavior selection filter B. This jumper selects different diodes for the Q circuit.
1-2 is Modern mode, 2-3 is Vintage mode.