Interlogix Simon XT User Manual - Manual (Page 31)

Simon XT User Manual 25
Top-level menus
This section explains the top-level menus, with the exception of system
programming, which makes up the bulk of the menus and can be found in its own
section, System programming on page 31.
Set clock
If the panel loses both AC and battery power, then upon restoring power the
system time will default to midnight and blink, indicating it has not been set
correctly. Your installer can set your system time to display in either 12-hour or
24-hour format.
Time of day format is HH:MMx
Where:
HH = 01 to 12 (12-hour format) or 00-23 (24-hour format)
MM = 00 to 59
x = a or p (12-hour format) or none (24-hour format)
To reset the clock:
1. Scroll up/down until the display shows Set Clock.
2. Press Enter.
3. The display shows Enter Code.
4. Enter your master code with numeric keys. Press Enter.
5. Press Enter again. The display now flashes the hours.
6. Scroll up/down to set the hours.
7. Press the Enter key to accept. The display now flashes the minutes.
8. Scroll up/down to set the minutes.
9. Press the Enter key to accept. The display is now flashing the AM/PM.
10. Scroll up/down to set the AM/PM.
11. Press Enter to accept. The display now shows the current time, and stops
flashing.
12. Press STATUS twice to exit.
Light schedules
Simon XT will automatically turn certain lights on or off according to light
schedules you can define in menu item System programming / Light control /
Light schedules. See Light control (optional) on page 14.
To enable or disable scheduled lights: