Philips CCZ194AT - Manual (Page 10)

10 Automatic Channel Setup
Although the TV/VCR may automatically memorize the channels
you receive when you turn it on for the first time, you may set up
channels again by following the steps below.
I
Press the COMBI button, then press the MENU button.
' to adjust press
> INPUT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION
1 CABLE i
J
2
Press the PLAY/A button or the STOP/T button to select
INPUT. Press the REW(ind)/-^ button or the F.FWD/^
button until ANTENNA or CABLE (whichever you have)
appears beside INPUT.
3
Press the STOP/T button repeatedly to select PRIM.
SETUP, then press the F.FWD/^ button.
PRIMARY SETUP
> SELECT LANGUAGE
AUTO PROGRAMMING
CH MEMORY REVIEW
VOLUME BAR [ON]
SET CLOCK
REMOTE LOCATOR
SELECT AT CHOOSE ►
TO END PRESS EXIT
4
Press the PLAY/A button or the STOP/V button to select
AUTO PROGRAMMING, then press the F.FWD/^ but­
ton.
AUTO PROGRAMMING MEMORIZED CH ...will appear on­
screen.The TV/VCR will memorize all available channels.
5
Wait for a few minutes.
When setup is complete, CHANNELS
ARE SET will appear on-screen.Then the programming of the low­
est channel number placed in the TV/VCR’s memory will appear
on-screen. Now, when you press the CH(annel). Up/Down but­
tons, you will scan only through channels you receive.
5
!2i'
Wait for the TV/VCR to set up
channels.
4
Helpful H ints
Line Input mode will always be
stored in the TVIVCR’s memory as
channel OO.You cannot delete it.
You cannot program channels when
the TV/VCR is on channel 00 (AIV
INPUT will appear beside INPUT at
step 2). Select ANTENNA or CABLE
at step 2.