Hooking upyourtv/vcr with a cable box, Hooking upyourtv/vcr with an indoor antenna, Hooking – Philips CCZ194AT User Manual
Page 6: The tvivcr
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6
Hooking
up
The TVIVCR
Hook up yourTVA^CR using one of the connections shown.
Aki
Hooking UpYourTV/VCR
With a Cable Signal or
Outdoor Antenna
B.
Hooking UpYourTV/VCR
With a Cable Box
To view any channel, set theTV/VCR
to the Cable Box output channel
(channel 03 or 04). Then, select chan
nels at the Cable Box.
Connect the Cable signal to
the IN Jack on the Cable Box.,
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on theTV/VCR.
f
iiiiiili—
Hooking UpYourTV/VCR
With an Indoor Antenna
To install a rod antenna (not sup
plied), push the stem of the antenna
into the antenna hole on the top of
the TV/VCR. Connect the antenna
wire to the ANT(enna) Jack on the
back of the TV/VCR as shown.
Extend the antenna and adjust its
length, direction, and angle for the
clearest picture.
Rod Antenna
(not supplied)