Philips CCZ194AT - Manual (Page 55)

Specifications I Glossary 55
Specifications
General
CRT: 19-inch in line gun
Television system: NTSC-M
Closed caption system: Section 15.119, FCC
(Federal Communications Commission) Standard
Video Heads: Four heads
Tape width: 1/2 inch (12.65 mm)
Tape speed
SP: 33.35 mm/sec.
LP: 16.67 mm/sec.
SLP: 11.12 mm/sec.
Operating Temperature: 4 l°F (5°C) to I04°F (40°C)
Relative Humidity: 10% to 75%
Power requirement: AC 120V, 60Hz
Power consumption: 90W
Sound output: IW
Dimensions:
19-11/16" (H) X 19-7/16" (W) X 18-5/16" (D)
500 mm x 494 mm x 465 mm
Weight: 44.1 lbs (20 kg)
Tuner Broadcast Channels
VHF 2-l3,UHF 14-69
Cable TV Channels
Midband:A - I
Superband: J -W
Hyperband: A-5 - A-1
Special Channel: 5A
Ultraband: 37 - 94, 100-125
Terminals
Antenna IN:VHF/UHF 75 ohms unbalanced
Video IN: RCA connector
Audio IN: RCA connector
Earphone: 3.5 mm CES
Electrical Specifications
Video input level: 0.5~2.0Vp-p
Audio input leveh-IOdBv
Video S/N ratio
SP: More than 42dBp
Audio S/N ratio
SP: More than 38dB
Designs and specifications are subject to change without
notice and without our legal obligation.
Glossary
AUDIO lack:
jack located on the front of the
TV/VCR which is used to record audio from anoth­
er source.
Automatic Channel Setup:
process in which the
TV/VCR scans all available channels and places the
ones you receive in its memory.Then, when you
push the CH(annel). Up/Down buttons, you only
scan through channels you receive.
Bands:
settings that allow you to tune channels.
• Antenna
- VHF (very high frequency; channels 2
- 13) and UHF (ultra high frequency; channels 14 -
69).
• Cable
- all standard channels can be received
without a Cable Box.
Brightness:
adjusting increases or decreases the
brightness of the color on-screen.
Color: adjusting pales or brightens the TV/VCR color.
Dubbing:
copying a tape using a VCR.
HO:
high quality; a feature in the TV/VCR circuitry
which provides enhanced picture detail.
Line Input:
The channel to which you set your
TV/VCR during dubbing.The line input channel is
always channel 00 (A/V IN).
Mode:
a TV/VCR operation.
OTR:
One-Touch Recording; programming a timed
recording that starts immediately and records for
30 minutes to eight hours, whichever you specify.
Picture: adjust to increase or decrease the con­
trast of the picture on-screen.
Sharpness:
adjusting softens or clarifies the picture
on-screen.
Tape Speeds:
how fast the tape travels during
playback or recording.
• SP
(standard play) - fastest tape speed (record­
ing time for a T120 tape is approximately two
hours); best picture quality.
• LP
(long play) - average tape speed (recording
time for a T120 tape is approximately four
hours).
• SLP (super long play) - slowest tape speed
(recording time for a T120 tape is approximately
six hours).
Tint;
adjusting changes the tints of the picture on the
TV/VCR from purple to green.
VCR:
video cassette recorder.
VIDEO lack:
jack located on the front of the
TV/VCR which is used to record video from anoth­
er source.