Cisco GigaStack WS-X3500-XL - Manual (Page 38)

Chapter 2 Installation
Attaching the GBIC Clip
2-6
Catalyst GigaStack Gigabit Interface Converter Hardware Installation Guide
78-6460-04
Attaching the GBIC Clip
Each GigaStack GBIC ships with a removable clip that can be attached to provide
extra security against accidental cable removal. If you use the clip, you must
attach it before inserting the GBIC into the slot.
Attach the clip as follows:
Step 1 Attach the clip to the GBIC by carefully inserting the clip tabs into the slots on
either side of the GBIC, in the orientation shown in
Figure 2-3 . Slide the clip
toward the port side of the GBIC.
Figure 2-3 Attaching the GBIC Clip
Step 2 Insert the cable connector into the GBIC port according to your configuration.
Step 3 Swing the GBIC clip up toward the GBIC so that the alignment bump in the clip
seats in the indentation on the GBIC bottom.
32256
1 2
GigaStack GBIC ports Alignment bump
Notches on clip
Tab