Philips CCX193AT - Manual (Page 26)

26 On-Screen Status Displays
A status display, which includes the current time, channel, and
other information (see illustration of the status display at right),
will appear when you press the STATUS/EXIT button or certain
function buttons.You can bring up the status display at any time by
pressing the STATUS/EXIT button. Remove the status display by
pressing this button again.The contents of the status display may
vary.
ON MODE:
o Whenever a function button (REW(ind)/-, PLAY/A,,etc.) is
pressed, the status display will appear for five seconds.
COUNTER ONLY MODE:
o When a function button (REW(ind)/-, Play/A, etc.) is pressed,
the status display will appear for five seconds. After five seconds,
only the counter will remain on-screen.To remove it, choose
ON or OFF in the ON-SCREEN MODE menu. (There is an
exception.When you press the STOP/V button, the status dis­
play will appear for five seconds, then disappear.)
OFF MODE:
o The status display will not appear when you press a function
button.The channel number will appear briefly when you select
a channel if channels are programmed.
Function
Counter
Memory
To choose an ON-SCREEN MODE, follow the steps below.
Press the MENU button to display the pop up menu.
Press the PLAY/A button or the STOP/T button to select
VCR SETUP.Then, press the F.FWD/+ button.
Press the Number 3 button to select ON-SCREEN
MODE.
Press the Number I button to select ON, the Number 2
button to select COUNTER ONLY, or the Number 3 but­
ton to select OFF. Your selection will appear on-screen.
Press the STATUS/EXIT button.
Helpfuf Hints
If the channel you select has no
broadcast^ the screen will be solid
blue. The screen will remain blue
until you select an active channel
Channel numbers (when tuned)
appear on-screen for a few seconds.
The channel number will remain on­
screen at all times (except during
tape playback) if REMINDER is set
to ON. Details are on page 27.
You cannot view closed captioning of
a tape when the V//VCR is in
Counter Only mode. To view closed
coitions of a tape, choose ON or
OFF in the ON-SCREEN MODE
menu. Details are on pages 42 - 43.