Philips CCX193AT - Manual (Page 51)

¡pedfleatiQm / Ш$шу SI
Specifications
General
CRT: 19-inch in line gun
Television system: NTSC-M
Closed caption system: Section 15. II9, FCC
(Federal Communications Commission) Standard
Video Heads:Two heads
Tape width: 1/2 inch (12.65 mm)
Tape speed
SP; 33.35 mm/sec.
LP: 16.67 mm/sec.
SLP: 11,12 mm/sec.
Operating Temperature: 4 TF (5“C) to I04°F (40“C)
Relative Humidity; 10% to 75%
Power requirement:AC 120V, 60Hz
Power consumption: 90W
Sound output: IW
Dimensions:
19-21/32" (H) X I9-7/I6" (W) x 18-1/32" (D)
499,5 mm x 494 mm x 458 mm
Weight; 46.3 lbs (21 kg)
Tuner Broadcast Channels
VHF2-I3,UHF 14-69
Cable TV Channels
2 - 1 3
Midband: A - i
Superband: J -W
Hyperband:A-5 - A-1
Special Channel: 5A
Ultraband: 37 - 94,100-125
Terminals
Antenna IN:VHF/UHF 75 ohms unbalanced
Video IN: RCA connector
Audio IN: RCA connector
Earphone: 3.5 mm CES
Electrical Specifications
Video input level: 0.5"-2.0Vp-p
Audio input level:-I0dBv
Video S/N ratio
SP: More than 42dBp
Audio S/N ratio
SP: More than 38dB
Designs and spedficatJons are subject to change without
notice and without our legal obligation.
AUDIO lack: jack located on the front of the
TV/VCR which is used to record audio from anoth­
er source.
Automatic Channel Programming: process in
which the TV/VCR scans all available channels and
places the ones you receive in its memory.Then,
when you push the CHANNEL Up/Down buttons,
you only scan through channels you receive.
Bands: settings that allow you to tune channels.
" Antenna -VHF (very high frequency; channels 2
- 13) and UHF (ultra high frequency; channels 14 -
69).
" Cable - all standard channels can be received
without a Cable Box,
Brightness: adjusting increases or decreases the
brightness of the color on-screen.
Cable Box Output Channel: 03 or 04.
Color adjusting pales or brightens the TV/VCR color.
Dubbing: copying a tape using aVCR.
HQ: high quality; a feature in the TV/VCR circuitry
which provides enhanced picture detail.
Line Input; The channel to which you set your
TV/VCR during dubbing.The line input channel is
always channel 00 (A/V IN).
Mode: a TV/VCR operation,
OTR: one touch recording; programming a timed
recording that starts immediately and records for
30 minutes to eight hours, whichever you specify.
Picture: adjust to increase or decrease the con­
trast of the picture on-screen.
Sharpness: adjusting softens or clarifies the picture
on-screen.
Tape Speeds: how fast the tape travels during
playback or a recording.
» SP (standard play) - fastest tape speed (record­
ing time for aTI20 tape is approximately two
hours); best picture quality.
“ LP (long play) - average tape speed (recording
time for aTI20 tape is approximately four
hours).
“ SLP (super long play) - slowest tape speed
(recording time for aTI20 tape is approximately
six hours).
Tint adjusting changes the tints of the picture on the
TV/VCR from purple to green.
VIDEO lack; jack located on the front of the
TV/VCR which is used to record video from anoth­
er source.