Cisco OL-15491-01 User Manual
Page 35
A-35
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
flags
•
0x80: Connection terminated because of lack of authorization failure.
–
0: The connection was not terminated as a result of an authorization failure.
–
1: The connection was terminated as a result of an authorization failure.
•
0x7E: Reserved.
The tcp flag values are:
•
0x01: Connection initiator.
–
0: The connection was initiated by the subscriber. The source address is associated with the user
ID.
–
1: The connection was initiated by the network. The destination address is associated with the
user ID.
•
0x02: TCP termination type.
–
0: Normal TCP termination (FIN or RST).
–
1: Connection timed out.
•
0x04: Persistent Connection (multiple sequential transactions per TCP connection).
–
0: The reported connection is not a persistent connection.
–
1: The reported connection is a persistent connection.
•
0x08: Destination Initiated Close (valid only if TCP termination type is 0).
–
0: The connection teardown was initiated by the source IP in the flow.
–
1: The connection teardown was initiated by the destination IP in the flow.
•
0x10: Destination Side FIN (valid only if TCP termination type is 0).
–
0: The destination side never sent a FIN (it might have sent an RST).
–
1: The destination side sent a FIN.
•
0x20: Source Side FIN (valid only if TCP termination type is 0).
–
0: The source side never sent a FIN (it might have sent an RST).
–
1: The source side sent a FIN.
•
0x40: Connection not closed (valid only for HTTP 1.1).
–
0: The connection has been closed.
–
1: The connection is not closed yet, and TCP close bits have no meaning.
•
0x80: Connection terminated because of lack of authorization failure.
–
0: The connection was not terminated as a result of an authorization failure.
–
1: The connection was terminated as a result of an authorization failure.
The wap flag values are:
•
0x00: Normal.
•
0x01: Aborted.
•
0x02: Incomplete.
•
0x04: Forced abort.