Cisco OL-15491-01 - Manual (Page 194)

A-194
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
meter exclude svc-idle
meter exclude svc-idle
To exclude the final service idle from the CSG2 usage calculation, use the meter exclude svc-idle
command in CSG2 service configuration mode. To return to the default behavior, use the no form of the
command.
meter exclude svc-idle
no meter exclude svc-idle
Syntax Description This command has no arguments or keywords.
Defaults The default behavior is to include the service-idle in the usage calculation.
Command Modes CSG2 service configuration
Command History
Usage Guidelines Configuration of this command can result in reduced charging because the next service access occurs
after the service idles, rather than occurring before the service idles.
You cannot configure both meter exclude svc-idle and basis byte or basis fixed in the same service.
Only basis second is meaningful with meter exclude svc-idle.
Examples The following example shows how to exclude the final service idle from the usage calculation for the
OFF_NET service:
ip csg service OFF_NET
meter exclude svc-idle
Related Commands
Release Modification
12.4(11)MD This command was migrated from CSG1.
Changes from CSG1: The meter exclude command split into three new
commands—meter exclude mms wap, meter exclude pause rtsp, and meter
exclude svc-idle.
Command Description
ip csg service Configures a CSG2 content billing service, and enters CSG2
service configuration mode.
meter exclude control sip Excludes call control packets for a Session Initiation Protocol (SIP)
session from the CSG2 usage calculation.
meter exclude mms wap Excludes bytes for a WAP 1.x Multimedia Messaging Service
(MMS) session from the CSG2 usage calculation.