Cisco OL-15491-01 - Manual (Page 203)

A-203
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
meter minimum
meter minimum
To specify the minimum number of quadrans debited by the CSG2 for a service or session, use the meter
minimum command in CSG2 service configuration mode. To return to the default behavior, use the no
form of the command.
meter minimum value
no meter minimum value
Syntax Description
Defaults The default number is 0 quadrans.
Command Modes CSG2 service configuration
Command History
Usage Guidelines If meter initial is set to 20 quadrans, and meter minimum is set to 90 quadrans, then the minimum total
charge is 110 quadrans.
If service duration is configured in the basis command, the usage is rounded up to the minimum value
when the Service Stop is sent. For a minimum value of 90, 150 seconds of network usage is not rounded
up for the purpose of calculating usage in the Service Stop, but, for example, 63 seconds of network
usage is rounded up to 90 quadrans.
Note The rounding-up of network usage is not reflected in calculations for the Usage
Tag-Length-Value (TLV) in Service Reauthorization Requests.
value Minimum number of quadrans debited for a service or session,
excluding the value in meter initial. For example, to force the CSG2
to debit 90 quadrans when less than 90 quadrans of network usage
were used for the service, specify meter minimum 90. If the initial
value is 20 quadrans and the minimum is 90 quadrans, then the
minimum total charge is 110 quadrans. The minimum value is
applied only if at least 1 session is granted network access for the
service.
The range is from 0 to 65535. The default value is 0.
Release Modification
12.4(11)MD This command was migrated from CSG1.
Changes from CSG1: None.