Cisco OL-15491-01 - Manual (Page 92)

A-92
Cisco Content Services Gateway - 2nd Generation Release 2.0 Installation and Configuration Guide
OL-15491-01
Appendix A CSG2 Command Reference
ip csg psd drain packet
ip csg psd drain packet
To define the number of packets to be drained from the Cisco Persistent Storage Device (PSD) per drain
delay interval when the Billing Mediation Agent (BMA) becomes active, use the ip csg psd drain
packet command in global configuration mode. To delete the drain packet, use the no form of this
command.
ip csg psd drain packet number-of-packets
no ip csg psd drain packet
Syntax Description
Defaults The default value is 500 packets.
Command Modes Global configuration
Command History
Usage Guidelines The CSG2 can buffer GTP’ messages in the Cisco Persistent Storage Device (PSD), if so configured.
(For more information, see the
“Configuring PSD Support” section on page 7-1 .) By default, the CSG2
limits the rate at which GTP’ messages are read from the PSD to 500 packets/second. However, you can
use the ip csg psd drain packet command to change that rate. For example, specifying that 1000 packets
are to be drained per interval yields a rate of 1000 packets/second (1000 packets/1 second).
Examples The following example shows how to specify that 1000 packets are to be drained from the PSD per drain
delay interval:
ip csg psd drain packet 1000
Related Commands
number-of-packets Number of packets to be drained from the PSD per drain delay interval. The
range is from 1 to 64000. The default is 500.
Release Modification
12.4(11)MD This command was introduced.
Command Description
ip csg psd Configures a Cisco Persistent Storage Device (PSD).
ip csg psd drain delay Defines the delay interval, in seconds, before draining packets from
the Cisco Persistent Storage Device (PSD) when the Billing
Mediation Agent (BMA) becomes active.